When it comes to oxyfuel cutting, one of the most common rookie mistakes is guessing gas pressure.

You might be tempted to crank up the regulator “just enough” or rely on what “feels right.” But here’s the truth:

> Eyeballing pressure leads to poor cuts, wasted gas, and dangerous outcomes.

One of the most common issues in metal fabrication is gate warping after installation. The gate looks square in the shop. It swings fine at first. Then weeks later, it starts dragging, binding, or misaligning.

This is not bad luck.

This is physics.

Let’s break down what is actually happening.

Progressive Welding Solutions uses laser welding not just for precision—but for next-level fabrication, clean finishes, and branded excellence.

A Practical, System-Driven Guide for Welders and Fabricators

Few things are more frustrating during an installation than discovering rebar right where your faucet, sink, or fixture needs to go. Rebar is designed to reinforce concrete, but when it’s poorly positioned or sitting in a critical spot, it can bring your entire project to a halt.

This exact challenge recently came up during a consulting call with The Fix It Dudes in St. Lucia. They were working on a professional installation when rebar blocked the space needed for fittings. They reached out to Progressive Welding Solutions (PWS) for guidance, and we walked through the process of cutting the steel safely without damaging the concrete.